Interested to Buy Any Domain ? << Click Here >> for more details...
One VFD is possible to connect two motors at the same time?
- 2 Answers
- 7209 Views
- I also Faced
- E-Mail Answers
Answer Posted / kunal salunkhe
It depends on the power rating of the power semiconductor
components used in VFD. Ideally the logic board which are
DSP based in most cases can be used to trigger two sets of
the power semiconductor converter circuits. but the power
semiconductor devices ratings decide whether you can connect
two motors to it or not.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Difference between ac parallel circuit and ac series circuit?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
What is relation between mu(nought) and epsilon(nought)?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
can we use trip light with bus coupler?
Differentiate between voltage and current feedback in amplifiers?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
for compensate 315mh inductance ,how many capaciance required?
What are the classifications of oscillators?
i need mat lab program to find out the transmission line losses,regulation and losses
What are the common sources of energy?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
What is difference between isolator and circuit breaker?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
