Answer Posted / krithi
the transformer works on mutual induction and mutual power
density principle.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
Can clean earth cable be considered as low current cable
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
how you will decide the distance between the power transformer and its fencing
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
What is different bewteen low or high impedance busbar protection scheme
Is there any specialised book to refer about fault level calculation both in MV and LV side??
How can we increase the capacity of Energy.?
what is the difference between capacitive and resistive voltage divider?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
can i use ups power as a raw power for another ups
What is dynamo?How it works and what is the function of dynamo in a DG.
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
whats the existence of reactive power and when it arises?