What is the basic difference between Latches and Flip flops?
- 99 Answers
- 178274 Views
- Bosch, Caritor, D Link, IBM, TCS, Thapar University, I also Faced
- E-Mail Answers
Answer Posted / dinesh budhwani
LATCH FLIP FLOP
1.its a ASYNCHRONUS device 1.its a SYNCHRONUS device.
2.its a LEVEL TRIGGERED device 2.its a EDGE TRIGGERED device.
3.it does NOT HAV a CLOCK PULSE. 3.it does HAV CLOCK PULSE.
4.USED as TEMPORARY BUFFERS. 4.USED as REGISTERS.
5.sensitive to the DURATION .5.SENSITIVE to d signal OF PULSES. change.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the difference diac and triac?
What is boolean algebra?
10 bit A/D converters,the quantization error in % is??
What type of Duplexer, Multi-coupler, Trans-receiver & Combiner used in 900 & 1800Mhz
whatis the test condition for the leakage current rating for 25kv high voltage test on PVC armoured cable?
describe the various addressing modes of 8085 processor, also provide an example of each.
plz send me previous question paper of RRB section Engineer- Electronics ,erpdayal@gmail.com
what is plc and how many type used plc in industrial field.
A channel has a bit rate of 4kbps and a propagation delay of 20msec. For what range of frame sizes does stop-and-wait give an efficiency of at least 50%
Two initially identical samples A and B of pure germanium are doped with donors to concentrations of 1*10, 20 m-3 and 3*10, 20 m-3 respectively. If the hole concentration in A is 9*10 12 m-3, then the hole concentration in B at the same temperature will be
whan type of controller is used in power plant?
In automation process timer based automation is best or not? any other possible methods are available
How many hours did the fuse tubelight glow after it connect it to the rectifier circuit?
What is a half-adder?
Name the equipments required for 2+2+2.
