Interested to Buy Any Domain ? << Click Here >> for more details...
what are the types of cooling systems used in motors?
- 2 Answers
- 9823 Views
- I also Faced
- E-Mail Answers
Answer Posted / kunal
Motors are generally cooled by three methods :
1. naturally ventilated: no special ventilation cooling by
natural conduction and radiation.
2. blower ventilated:
separate blower, with small external motor and filter
provided. which allows motor to accept additional external
air and force heated air out
3. separately ventilated motor:
separately ventilated by ducted air flow through the enclosure
more information can be found at
http://www.globalspec.com/reference/10786/179909/Chapter-3-AC-and-DC-Motors-DC-Motors-Enclosure-Types-and-Cooling-Methods
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
what is the usage of microcontroller in the panel board?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
What is the maximum and minimum rating of UPS?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
What is the minimum underground tank size capacity considered for firefighting purpose?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
Explain the advantages and disadvantages of thermal power plant?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
can i use 2000/5A Clamp meter to measure HT cable
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
what is vtg limit of earth and neutral at transformer side?
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Inverter. converter. Ups.MCB.solar.alternators. motors.
