Answer Posted / pradeep
capicitors are normally used to improve the power factor.
because of this it is used in meters.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
why 1.7Uo for HV cable Hi pot test?IE standard why?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
How are load losses and no-load losses measured at site in a DG set?
11000volt DG set carnt kaise banvay
briefly explain the main blocks found in a microprocessor based system
What is the function of electron gun used in crt?
how to check regenerative load in drived motor
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
how to calculate compresor capacity?
what are the specifications we must look at to select a relay for any capacity motor?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
why is control bus bi-directional?
