Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between 1/2"NPT & M20 x 1.5 cable gland?
- 8 Answers
- 92185 Views
- I also Faced
- E-Mail Answers
Answer Posted / gobinath
1/2" NPT size of theard for cable gland
M20x1.5 Cable gland for 1.5 sq mm cable
In General two typs of Theard mounting avilable.
1. mm theard
2. Inch Theard
Here 1/2" NPT - Inch Theard
| Is This Answer Correct ? | 21 Yes | 42 No |
Post New Answer View All Answers
Conversions
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
how to tune siemens sipart electro pneumatic positioner..plz tel me..
State bernoulli’s application.
TEMPERATURE VARIATION FOR FREQUENTLY.
What is Erosion in a control valve?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
Why trim span ? How?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
why we are using magnet for calibration of gas detector?
Square root calculation for dp flow transmitter?
