Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if DC supply is given on the primary of a
transformer?
- 6 Answers
- 9988 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrinal
Mainly transformer has high inductance and low resistance.
in case of DC supply inductance will not act only
resistance will act in the circuit. So high current will
flow through primary side of the transformer. for this
reason coil and insulation will burn out.
| Is This Answer Correct ? | 33 Yes | 0 No |
Post New Answer View All Answers
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
trasnfarmaer core make
How line capacitance & line inductance varies with increase in height tower.
What is a dominant pole?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
What aturn on methods of scr?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
What kinds of decision are made about CT from it's Knee point(voltage & current)?
