Answer Posted / arun kumar
It is the cosine angle between the voltage and current.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
how does a submersible pump work..?
What are the commonly used schemes for the bus zone protection?
why ht cable end termination don't have a gland?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Comment on the working principle of operation of a single-phase transformer.
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
what parameters are should nessary for control technic dc drive(in rolling mills)?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
What is different bewteen low or high impedance busbar protection scheme
How can we checked Killo Watts of Motor & Alternator?
WHAT IS DEAD END IN PROTECTION?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?