Answer Posted / ankush miglani 09718151073
rms is root mean square
it is noted in ac votage or power or current
it is always less tggan the peak value
if one work is done by dc voltage say heat producing
then the same heat is produced by the ac voltage
the ac voltage is known as rns value
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what parameters should we check to reduce the power bill
how much excitation voltage required to generate 1mw power?
how to test YNyn0 vector group in transformer?
how we can calculate chiller required ampear?
Define ampere
WHAT IS DEAD END IN PROTECTION?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
Difference between transition and diffusion capacitance
How to calculate the size of earth cable to earth the neutral of UPS ?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
What is negative sequence over voltage element?
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is an automatic controller?