Lap length may different for FE 415 and FE 500 Steel, If
different what is the different, In which code is mentioned
Answer Posted / shiv
In General Practice, Lap Length is depended upon the
diameter of the bar which we are going to used for lapping.
It is usually taken between 0.4d to 0.6d ...
Is This Answer Correct ? | 41 Yes | 8 No |
Post New Answer View All Answers
Spider cracks occur in beam bottom due to––
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
IS code for Rolling Margin of steel
how much cement and sand consuptin in 4 inch siporex walls 100 sq ft
Formula for calculating the volume of bulb in underreamed pile
sir i want to know that in L & T construction can we do our 6 months training proggramme cum placement???????
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
What is geopolymer based concrete?
Define What is Civil Engineering?
what radial pressure, the NP2 class rcc pipe can sustain?
1:4:8 pcc calculation 591 cu.ft
what is SDLC ?and write a 'c'program for to swapping the three numbers?
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
what is the use in canals of longitudinal drains and cross drains in lining areas?
How to determine spacing of bars in slabs or beams