WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT
THE TEMP ARE 0,30,250,320
- 13 Answers
- 18771 Views
- I also Faced
- E-Mail Answers
Answer Posted / kamalakannan
temp is zero once shortcicuit fuse will damaged so temp
showing is 0
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
i want to find out iffco get test paper
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
Explain an adaptive / self-tuning controller’s major draw card.
How hart protocol can be connected with control valves?
why would you like to join our company
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
how to relay switch sense the fault?
how the arrangement of equipments done in control room
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
What is cut off relay? And why use in PLC and DCS?
What are the interlocks we have to check during the start up of LP/HP compressor?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is wave length were using ?
