Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT WILL HAPPEN IF INPUT SUPPLY OF RCBO IS CONNECTED TO
OUTPUT SIDE
- 2 Answers
- 6097 Views
- ABG Shipyard, I also Faced
- E-Mail Answers
Answer Posted / ankush miglani 09718151073
i havnt check yet
bt as per me at that time the relay will not work and the
rcbo gets damaged
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
What is DTR erection?
how can i get an electrical c-certificate?
why the value of k is more in shell typr transformers?
what is negative d.c. voltage, why this voltage is used in base transciever station.
What happens if the series current double?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
Define peak overshoot.
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
What is the Nyquist criterion regarding control systems?
