How to calculate cable size in sq units based on motor rating
is KW
- 2 Answers
- 5736 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhas
Usualy in large industries the cable size is calculated,
for 1A of current its 1 sq mm of aluminium cable and 0.5sq
mm of copper cable.
Ex: In case 600A : 300 sqmm or 2R x 150 sqmm cable to be
preferable. in same case iys 150sqmm of copper cable is
enough.
Prabhas
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
what is saturation kit?which use above 15 kw motors panel side.
What is the use of oil in transformers?
how to modify DOL control panel into Delta Y connection?
how to calculate single phase motor efficiency ?
Can I use star delta connected induction motor for dual supply voltage?
State ohm’s law?
What is the function of attenuator in cro?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
How we can defined theecopper cable size if we know the aluminium cable size?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How can calculate the rating of a alternator for a given specific load with formula
132/66kv sub-station procation ?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
Explain cos(theta) and Sin(theta)
