Interested to Buy Any Domain ? << Click Here >> for more details...
My present SMPS ( +12V, -12V outputs, 1Amp Rating ) was
faulty.I donot have similar model however i have two + 12V
SMPS available. Can i use both of these SMPS as a
replacement to present SMPS by connecting one of SMPS in
reverese polarity.
- 2 Answers
- 4613 Views
- I also Faced
- E-Mail Answers
Answer Posted / satish kumar dhiman
You have to Make common of + 12v of on power supply on -ve
of another supply than may be you get results.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the commonly used filters?
Which of the transistor currents is always the largest? Which is always the smallest? Which two currents are relatively close in magnitude?
When we trim a resistor, we are A Making a fine adjustment B Reducing its value C Increasing its value D Making a coarse adjustment
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
What is meant by pwm control in dc chopper?
pls. send me 10 years modle papers for the post of section engg. (E&C) in rrb ajmer, at my mail id i.e. praveen.yugal@gmail.com.
Explain inductance?
Why is silicon preferred over germanium in the manufacture of semiconductor devices?
WHAT IS DIFFERENCE BETWEEN. WRITE: a+m(2). m = m + 1. + OF THESE TWO IN SAP ABAP
what were the challenges you faced during the project technically and how did you cope up with that?
What is a step-recovery diode and why is it so called ?
please somebody who have asked questions related to electronic and communication eng siemens 2010-2012 post here
What are the KPI that decides the capacity expansion of SGSN/MME?
how do work current transformer?
iam an electronics & comm engg student.i have applied for AAI can u please forward the old and related question papers to my id lali.ece63@gmail.com
