Interested to Buy Any Domain ? << Click Here >> for more details...
what is the role of half nut in thread cutting? how can u
cut the thread from 8 TPI to 4 TPI?
- 2 Answers
- 5715 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / gopimech312
Normally we give the tool feed by means of hand wheel, but
it is not uniform. so we use the half nut. when we engaged
the half nut then the tool will move automatically in
longitudinal direction as per given pitch
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What happen when too much cylinder oil is injected in the working cylinder?
What is vane diagram in centrifugal pump?
what is the fuction of asstt. rigman drilling
What type of pump use in boiler F.O. system?
Can we add different application (program)in pro e modelling software? If YES ,then how????????
What are the causes of failure of boiler tubes ?
What are different types of gate valves?
Give an example of a time when you had to explain some new procedures to your co-workers for quality service delivery. How did you go about it?
What is the use of rasp file?
What are the causes of failure of superheater tubes ?
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
what is an function of air cell bag in air cell conservator
what shows avribiations related to bearing blocks
WHAT IS THE TOTAL HEAT RATE OF PLANT AND WHAT IS THE HEAT RATE OF BOILER?
Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?
