Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following can be operated at higher frequencies
?
-SCR
-MOSFET
-IGBT
- 4 Answers
- 6707 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
Undoubtly,
MOSFET.It has the high switching frequency of
around 100khz.
SCR - 2khz
IGBT - 20khz
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
What is the difference between earthing,ground&nutral?
How can you sized or estimate the ligthning arrester current rating?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What is the use of lag compensator?
Compare jfet’s and mosfet’s.
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
