Answer Posted / j@ru ( sati)
i am agree wiyh above all and adding that the ac
transmission is cheaper at a distance called breakdown
distance which is about 800-1000 km .above this distance of
transmission line dc is cheaper ..but it should be noted
that the initial cost of installation for dc is more than
ac.as rectifier station installation is costly.
thank you
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
State kirchoff voltage law?
How to choose size of the cable w.r.to current carrying capacity ...
what is the importance of earthing system on the generators big capacity and small?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
for a 400kv t/m line with 10 ampere current will corona occur?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
what is the difference between earth leakage and earth fault?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
how we do Vector group ,magnetic balance and tap changer test in Transformer?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
