Answer Posted / bhogayta jitendra
first isolate the transmitter & connect with HART.then
check all parameter & range.high side port connect to
scandura calibrater & low side port open to atm.then give
the pressure according to transmitter range.output required
linear in 4/20.
| Is This Answer Correct ? | 16 Yes | 13 No |
Post New Answer View All Answers
what is the difference between scaler and vector drive
In turbine what does term CDP, NH, HSSOC means.
what is the process for double acting cylinder pneumatic for 32' v/v
Explain the working principle of lvdt?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Describe a time when you anticipated potential problems and developed preventive measures.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
what are the values of fuel flow rate in various places in boiler.
If we increase only P what will be controller action ?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
Question on maha cement
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
How the sizing of the analog signal cable is calculate?
How to calibrate an pressure gauge with yantrika test bench?
