an electric bulb is connected on a holder. one end of the wire
is connected to the phase and the remaining one connected to
earth instead of neutral. the bulb will glow or not? if yes
then what is the need of neutral?
- 7 Answers
- 11708 Views
- I also Faced
- E-Mail Answers
Answer Posted / jkth
then wat is the need of neutral?
we can connect the secondary of transformer as delta
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is meant by re-rolling motor? how it differs from standard motor?
What is the lower limit of break-down voltage of converter transformer.
How to Make relay co ordination chart for a Electrical power distribution of a plant
Why we use mho Relay in long transmission line?
what may the reason for vector shift in a generator?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
In radial network the source is fed from 1 end both ends at central
Why does the rotor rotate?
I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
State ohm’s law?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
Explain Random and Deterministic signals?
