Answer Posted / amolkarne

also 10.Duty cycle (continuous/intermittent etc)
11.Class of insulation (Y/A/E/B/F/H/C)
12.Rated CURRENT ( in Amp.)
13.Rated Voltage (in Volt.)
ETC.............

Grid fault level [KA]?

2613

---

What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?

2423

---

What is I to C?

2156

---

If short circuit ratio is high is it bad or good for a machine then tell the reason...

2040

---

What type of DC motor would you see for a lift?

1095

---

What descriptive information does the NEC require to be marked on all conductors?

2012

---

What products have you designed which have entered high volume production?

2065

---

In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.

1756

---

What is difference between insulating medium and fault current interruption medium in a switching device.

1662

---

What is resonant frequency?

1281

---

What is the difference between solid grounding and impedance grounding?

2121

---

What is ST and specify its range of voltage.

1977

---

66kv under ground cable how to layaing in ground any special case two ckt r runing

1997

---

what are the disadvantages in GIS over AIS

2426

---

what is the principle of operation of tungstun bulb ??

1830

---