Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / haridass
If there is zero error, the output will be minimum peak of
3.1 mA. If it like 2.2mA, the transmitter electronics may
be problem. Interchange with good transmitter and check.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
With N nodes and B branches what will have a network ???
plz send me general of ongc
How to work togather like sov,limit switch,proxy switch and booster in xv
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
What is zener diode? What is voltage regulator?
In turbine what does term CDP, NH, HSSOC means.
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
Explain why plc require in analog input 4-20amp & 0-10 volt?
what is the reason while warning lamp is on while the engine is cranking?
What are different types of orifice plates?
what is KV and XV valve
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
which type inter lock use in petrochemical refinery,and oil & gas?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
