Interested to Buy Any Domain ? << Click Here >> for more details...
Why transformer neutral earthing? What is advantages?
- 3 Answers
- 6639 Views
- I also Faced
- E-Mail Answers
Answer Posted / narayanan
protect to the transformer,
human safety
short circuit for protect the transformer
eb line neutral earthing is not work to support neutral
earth
constant voltage
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
how much excitation voltage required to generate 1mw power?
raleigh method
all details of DG UPS HVAC
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
What are gain margin and phase margin?
How 3 phase invertor works?
Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
3phase motor can be used as a Prime mover for alternator.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to changeover ups in this power failur time?
