can we check the resistance of earthing electrode while it
is connected with the neutral of UPS system
Answer Posted / anil
now days simple measuring instrument are availsble eg:-
meco i have seen catloge by which without connecting to
Eatrh Electrode we can measure leackage current as well as
resistance of Earth point/Electrod.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
what is there inside an inverter and how it works?
the winding of Generator and Motor is star or in delta ? and why
any one can explain the stages of a knee point which is taken during ct magnetising curve.
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
Define sensitivity?
What is the name of transformers oil filteration equipment?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
Which device is used for the source of emission of electrons in a crt?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
Leakage current,un balance current which relay using for high voltage transmission?