Interested to Buy Any Domain ? << Click Here >> for more details...
Why do we use diesal engine for heavy machinery and not petrol?
- 11 Answers
- 16831 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay
The Compression ratio is calculated by the following
formula:
CR= ((3.14*b^2/4*s+Vc)+VC) / Vc
, where
b = cylinder bore (diameter)
s = piston stroke length
Vc = clearance volume.
In deisel Engine the compression ratio is in the range of
20:1 to 25:1, which is very high as compared to Petrol
engine. for same bore dia, the stroke is bigger in case of
a diesel engine that is why for heavy engine diesel engine
is suitable than petrol engine.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
which power station plants r more efficient? which is less? which is most expensive and which is cheapest?
What is the purpose of scrapper ring
What will cause if you run your engine in critical RPM continuously?
Which reactor uses heavy water as moderator ?
3-4 questions on optical fiber : data based.
Do you work for many hours each day?
What is the power requirement of a refrigerator?
in aviation, How does control valves work?
Explain important rules that must be kept in mind while designing castings?
Sir we wants to const ruct a wall,size wall is 50x30x9/12' feet.how many bricks required. Please advise
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What parameters to be reported when we send lubricating oil for shore analysis?
hi friends pls send the bhel question papers is very urgent...
Did you have a favorite project that you had to do while in school?
How much is 1 kn in kg?
