Interested to Buy Any Domain ? << Click Here >> for more details...
Please explain about FAT? What is the difference between
FAT and SAT?
- 6 Answers
- 33044 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / visakh
hello shanker
these to tests are nothing but to check all the instruments
or materials are in good condition(means damaged or not)
| Is This Answer Correct ? | 1 Yes | 11 No |
Post New Answer View All Answers
How to check vortex flow meter is in good condition while we do not having calibration setup?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
2. What is ultrasonic flowmeter?
in mass flow meter what is drive friquancy ?
what is the process to make control schematic ?
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
what is the difference between attemperator and desuperheater ?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
How to calculate mmwc values into tonnes?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
what is piezoelectric transducer?give an example in power plant n state its principle?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
