Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manobalan
DC IS DANGEROUS
REASON:CONSIDERING SAME PEAK VOLTAGE LEVEL ATLEAST THERE IS
MEAN VOLTAGE ZERO IN AC BUT THAT IS NOT IN DC....
| Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is the difference between c power and U power acb breaker
What are the weight of 800KV DA,DB and DC type tower ?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
how to carried out DAR test in 11 KV Alternator ?
why the protection turbo generators is most complex?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
whati s the sludge current in ups
what is the principle of operation of CFL ??
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
