Interested to Buy Any Domain ? << Click Here >> for more details...
ON WHAT BASIS LOADS ARE CLASSIFIED AS RESISTIVE,INDUCTIVE
AND CAPACITIVE LOADS?.GIVE PRACTICAL EXAMPLES FOR EACH
- 6 Answers
- 24095 Views
- I also Faced
- E-Mail Answers
Answer Posted / mathmatical-crasher-abid
ON WHAT BASIS LOADS ARE CLASSIFIED AS RESISTIVE,INDUCTIVE
AND CAPACITIVE LOADS?
answer :
resistive loads means any loads those show no phase difference between current and voltage. its power factor is 1.
EXAMPLEs are light bulbs, heaters.etc
Induction Loads show phase difference between currents and voltages. here current lags the voltage by 90 degree. power factor is negative.
examples are FAN, induction motors, fluorescent lights. etc
Capacitive loads show phase defference but here currents lead the voltages by 90 degree. here power factor of capative load is positive.
examples are synchronous motors, capacitor banks. [capacitor load's number is very few. ]
| Is This Answer Correct ? | 8 Yes | 5 No |
Post New Answer View All Answers
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
what is circuit recombiner and how it is different from circuit breaker
why we need to us lenz's law for synchornous motor
what exactly commisioning work does in electrical site work... LT side?..
what type of motor used to move a 1 ton gate? and relate ratings with load.
What is the significance of integral controller and derivative controller in a pid controller?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
What is meant by reactance voltage?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
what is is the potential diffrence between two phase ?
Why need 3phase machine double earthing?
