Answer Posted / sunil ulange
ALL TRANSFORMERS RATING ARE IN KVA BECAUSE TRANSFORMER IS
INDEPENDENT OF POWER FACTOR AND TRANSFORMER WILL NOT ACT AS
A LOAD, IT ONLY TRANSFERS VOLTAGE FROM ONE LEVEL TO OTHER LEVEL.
KVA = KILO( VOLTS * AMPERES )
NORMALLY REACTORS RATINGS ARE IN KVAR
| Is This Answer Correct ? | 20 Yes | 3 No |
Post New Answer View All Answers
What is nichols chart?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
What happens to a motor if it is connected in Delta connection
at which voltage level arcing ground is occurs ??????????
Write the force balance equation of m ideal mass element.
why output is out of phase in case of common emitter?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
Explain the working of variable frequency transformer?
How you calculate the repturing capacity of a HRC fuse
What is zero of the system?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage