Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / elango.kalp
energy efficent motors means losses are minimised.
1.area of cross section of conductor have been increased to
reduce copper loss.
2.thickness of lamnination has been reduced and crgo
technique has been used.
3.c3 ballbearings have been used it has good clearance
between each rollers and lubrication is proper-friction
loss is reduced
4.rotor length is increased and air gap b/w stator and
rotor is reduced- windage loss is reduced
5.plastic fan has been used
the over all efficency of energy efficient motor is 93.6%
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is difference between mcb and mccb.
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
What is block diagram?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
What is the maximum percentage voltage drop (vd%)for a motor control center
diameter of cable and core is doubled then the value of capacitance is
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
Explain the advantages and disadvantages of hydropower plant?
How RTCC panel is working and give single line diagram for RTCC with transformer?
What is vacuum circuit breaker.define with cause and where be use it device?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
