Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / james
The working and principle of all types of compressors are
given in detail...goto
http://hubpages.com/hub/compressors
| Is This Answer Correct ? | 17 Yes | 5 No |
Post New Answer View All Answers
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
How to calculate phase to phase difference ?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What are the types of transformers according to the arrangement of iron cores?
Define what is power quality meter ?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
what are factors to be consider in electrical installation like load factor,diversity factor .....
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
what is the difference between directional & non directional earth fault with example please explain.
What is resolver and glass scale in CNC how they work?
Why the output of OP-AMP is always less than Vcc?
