how can we calculate the cutting length of 10,12,16,20 and
so on iron bars for 45 digree and 90 digree bents plz tell
me if there is any formula or tabel to find it
Answer Posted / prabhu
The answer posted should some reference from any of IS code.
It has to be justified.
As i refered code IS 2502 BS 4466 the deductions followed are
0 for 45 bends
d<= 16 dia for 90 bends
2d>=20 dia for 90 bends
Is This Answer Correct ? | 37 Yes | 14 No |
Post New Answer View All Answers
what is pqc
Would you cause a 55-gallon drum of water to weigh more by climbing in?
The concrete slump recommended for beams and slabs; is?
how to find out hard strata in bored pile when the DMC method adopted.
what is the effect of duration of earth quake on framed structures ?
how water proof chemicals act in concrete to avoid leek?
How to construct a water sump in a rocky soil?
how can we construct building without foundation providing only grade beam at ground level
what is hydrostatic paradox?
i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh
What is Critical path in Ms-Project ?
what is conventional shuttering rate per square feet of built up area? what is Mivan shuttering rate per square feet of built up area? what is coupler shuttering rate per square feet of built up area?
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step
what is the steel difference between np-2 and np-3 pipes and weight also
What is the strength of 1:6:12 mix?