Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between power and distribution
transformer?
- 32 Answers
- 68566 Views
- L&T, VJTI, Wenke Electricals, I also Faced
- E-Mail Answers
Answer Posted / amit sharma
power transformer transforms all the negative power of
hu(man) body into fluid and brings(steps)it down through
penis to distribute it in vagina.
distribution transformer suck my dick.
| Is This Answer Correct ? | 0 Yes | 16 No |
Post New Answer View All Answers
what is vA rating and class of a ct.
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
What is the formula of frequency ?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the difference between voltages or potential difference? And what are they?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
why capacitive load is not used in routine life????any reason is there ??????
how many stairs have you climbed while you were coming
A low wet bulb temperature indicates
How to improve fuel cell in a distribution system?
please send me previose rrb junior engineer qustion papers
What is trip and closing coil in cb? Why need of them
how to calculate the size of the HT cable
