Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between MPCB and OLR?
- 11 Answers
- 59324 Views
- ABB, Raj Agencies, I also Faced
- E-Mail Answers
Answer Posted / sachin
MPCB is device which has inbuilt OLR+Short circuit
connected to Trip coil.
In event of fault like oveload OLR coil will sense and give
command to trip coil to trip.
In event of Short circuit fault SC coil will energise
inside MPCB and trip circuit breaker.
In case of OLR over load relay, its only a primary device
which senses only over loads.We need to connect contactor
to break the circuit.
| Is This Answer Correct ? | 44 Yes | 3 No |
Post New Answer View All Answers
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
How earthing of switchgear system to be done.
What is ST and specify its range of voltage.
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
what is the minimum winding resistance of 30hp compressor, to run or to switch on
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Why you want to join non technical field when you are an engineer?
How much load can take a 16 mm aluminum cable 3 phase
What is the drawback of class b amplifier? How is this minimized?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
