Interested to Buy Any Domain ? << Click Here >> for more details...
How to get -10volts DC from 10 volts peak to peak sine
wave?? Design the circuit??
- 10 Answers
- 14745 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / velthe chipmaker
Give the 10v ac to primary of the transformer . (input of
the transformer is 10v &out is 15v by using the step up
transformer)
it will give pulsetting dc, (pulsetting dc means dc power
with some ac componant).
then the pulsetting dc is given to the full wave rectifier .
rectified output is abow 10v so voltage regulater is used to
produce 1oV dc supply.
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
What happens to the series current , load current and zener current when the dc input voltage of a zener regulator increases?
Tell me why do we convert frequency domain to laplace domain?
What is am.
what is an integrator?
Why iceo >> icbo?
What is meant by mcmurray inverter?
What is a step-recovery diode and why is it so called ?
sir, pls send me 5 year previous question papers of RRB- Junior Engineer-GrII to my mail id
What is meant by voltage commutation?
Explain the different steps of Commissioning.
compare the delay in sending x-bit msg over k-hop path in ckt switched nw nin lightil loaded packet swithed nw. the ckt setup time is s per hop,the packet size is p bits n data rate is' b' bps under what condition does packet nw have lower delay?
Name the breakdown mechanism in a highly doped p-n junction under reverse biased condition.
Although zener diode is operated in the reverse breakdown region, but it does not burn. Why?
What is angle and amplitude modulation?
Explain why is the diffusion technique of formation of resistor most widely used?
