Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / priyabrata swain
10^-6
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
Linear amplifier.
How RAL(Rotary air lock)works in cement industry?
Can I calibrate the Electromagnetic Flow Meter on line and How.
What is Span Error
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Explain the working of an enraf level gauge.
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
How to calibrate H2s Dectector
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
you are on site,the plant trips,you are approached by operations,what do you do?
