Interested to Buy Any Domain ? << Click Here >> for more details...
What is diff between Ingral orifice and simple orifice?where
it use?
- 3 Answers
- 6331 Views
- I also Faced
- E-Mail Answers
Answer Posted / shan259
Generally intergral orifice can be used for the line sizes
less than 1 inch. Integral orifices are connected with
transmitters. It is a whole assembly. We just procure it
and install in the pipe. No additional impluse tubing wok
to be carried out.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the importance of CV in the control valves? how it is calculated?
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
Why not come out analog output in ABB EL3020 when display show correct value
hi! i want to know about mpse exam.
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
Calibration procedure for electro magnetic flow meter
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is the use of double seated valve?
How to Calibrate Ultrasonic Level Transmitter in field
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
field bus transmitter calibration procedure tell me
how to measure oxygen which methods are using?
