Interested to Buy Any Domain ? << Click Here >> for more details...
I have seen the Temperature element (T/C & RTD) installed
in process line on 45 degree position, Why? What it mean?
How many types of tapping position for temperature elements?
- 4 Answers
- 11956 Views
- I also Faced
- E-Mail Answers
Answer Posted / shan259
Normally it will mounted perpendicular to the piping.
might be to avoid loss in pressure or flow.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
How flow can be measured with dp?
What are different types of orifice plates? State their uses.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
Any body have know try work calculation ???
what is compensation? temprature & pressure
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Explain the combusion chamber
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
what is cold loop? difference between hot and cold loop?
how to check earthing,what is minum ohms for proper earthing
What is loop1 and loop2 in MTS LT?
