Answer Posted / rohit mathanker
there is four angle use in twist drill
1 cutting angle it is 118 is quite common but very 80 to
140 degree soft material required large value of it wherse
hard material required low value.
2 lip clearance angle its value varies 8 to 14
3 rake angle it is large for hard material because for
removeing the chip and small for hard material
Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
Name two types of leak detectors and the method of application for each?
Explain why would some industries select pneumatics over hydraulic?
how to calculate duct fittings surface area ?
how to prepare welding procedure specification and pqr
What do you understand by fuel cycle in nuclear plants ?
for under water excavation works, can i have some standard codes and specifications(international)
What are to be checked in an induction motor?
What is the mechanical advantage of a double pulley?
HOW CAN WE MEASURE THE L SHAPE SURFACE OF THE MOMENT OF INERTIA AND SECTION MODULUS
material grade c 45
What is the temprature used in dearator tank?
What is difference between Higher calorific value and lower calorific value?
Define a slined joint?
What are the things needed to have an efficient boiler burning?
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?