How can CALCULAT the current carrying capacity of aluminum
and cOpper cables respective of that Sq.mm ? with
formulas ?
- 12 Answers
- 188599 Views
- Bajaj, Eagle, Godawari Power and Ispat, Havells, L&T, Mascot, Polycab, SGML, Sterling Wilson, I also Faced
- E-Mail Answers
Answer Posted / amitamit makanbacem
read the datasheet of cable factory, don't play smart with
formulas, u stupid dumbass
| Is This Answer Correct ? | 48 Yes | 78 No |
Post New Answer View All Answers
What are different types of control systems?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
What is the difference between a verilog task and a verilog function?
How much dc volt applied in cathodic protection system?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is VCB? where it is installed at SP. What is SP?
what are the things that can cause a three phase motor to crawl?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
difference between servo motor and synchronous motor
What is stepper motor. What is its uses?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
can i use ups power as a raw power for another ups
how to calculate fault level?
