Answer Posted / prince
Anti-pumping relay is used for protecting the closing coil
of the circuit breaker.The Anti-pumping relay contact(NC)
has been taken in series to the CB closing circuit.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How to minimize the eddy current losses?
How phase displacement change in the over current relay coils.
gas turbine genrator reactances
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
What is the formula to calculate the rating of power cable for three phase current.
what are the interview question asked in wind mill about electrical
how invertor convert the dc into ac give brif detail
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
how to deside the capacity of chock for drive?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
What are the main faults of DC generators?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai