Interested to Buy Any Domain ? << Click Here >> for more details...
What is the role and reponsibilities of Electrical
Engineers in construction field?
- 12 Answers
- 90178 Views
- ETA, Garg Electronics, L&T, I also Faced
- E-Mail Answers
Answer Posted / shiva
Ensure the power supply 24x7.
ensure all the provisions for electrical systems in place
for future n present
| Is This Answer Correct ? | 24 Yes | 15 No |
Post New Answer View All Answers
what happens when series resonance occurs?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what work will do diffrential realay DG set
Why squirrel cage motor can only use with low starting loads ?
where rlc series ckt used?
How to decide cable tray size?
cc of scorpio?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
as a electrical student why should i hire you?
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
how is capacitor bank look like
how could we calculate the no of outgoings from a 800 watt distribution board
can the measured percentage error during calibration of single phase energy meter be negative?
why electronic instruments is more favorable than electrical?
