Explain the working principle of Synchronous Generator and
Assynchronous generator?
Answer Posted / engr arslan ghaffar
Synchronous generators are synchronous machines use to convert mechanical power to electrical power. in synchronous generator a DC current is applied to the rotor winding, which produces a rotor magnetic field. The rotor of the generator is then turned by a prime mover, producing a rotating magnetic field within the machine. this rotating magnetic field induces a three phase set of voltages within the stator windings of the generator.
| Is This Answer Correct ? | 26 Yes | 2 No |
Post New Answer View All Answers
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
for 750 kw LT load what will be the ht kva
What are the advantages of speed control using thyristor?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
How To increase Knowledge Of boliler regarding To Only Electrical Field..
Control wiring of a dol starter for forward and backward
How is magnetic leakage reduced?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
what is current check gurd relay?
what is the breaking capacity and making capacity of circuit breaker and how
Which is the largest hydropower station in the world?
what is differentila pilot supervision in the incomer control panel in the power station?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?