Interested to Buy Any Domain ? << Click Here >> for more details...
If 440 V supply has given at the secondary winding of
transformer at that time if we apply 11 KV at primery then
what will happen???????
- 4 Answers
- 7374 Views
- I also Faced
- E-Mail Answers
Answer Posted / s c budhiraja
nothing will happen if rated voltage is applied to both the
windings
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
How to calculate Air conditioning capacity for a telecom BTS shelter?
how wecalculate breaking capcity of acb mcb mccb .explain with example
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how does an encoder work???
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
by what factor the starting current is used when comparing star and delta connection for motor starting?
What are the raitings of Mcb,mccb and Acb in detail ??
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
what is meant by carrier aided trip protection in transmission line
why the neutral point in connnection oscillates?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
