Answer Posted / marques, joão
The heating time constant is the time required for a
electric motor to attain 63.2% of it's final temperature
for a fixed power input.
| Is This Answer Correct ? | 47 Yes | 7 No |
Post New Answer View All Answers
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
what is the purpose of bypass mode in energy lighting transformer?
How you will determine the volume of oil in a particular Distribution transformer.
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
What is the range of the stator resistance of 3 phase induction motor?
where we use the SFU & FSU?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
what is submersible pump?what is different between motor and sub motor?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?