What is load staggering or load shifting in the context of
power distribution?
Answer Posted / iamdon
Load staggering means, In stead of having single peak at a
particular instant of time there are multiple(3 or more)
peaks in the close proximity of that particular instant of
time.It helps in achieving high load factor.
This can be achieved by.
1)Employing different time zone concept.
2)Encourasing the use of electricity in off load periods.etc
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is resonant peak?
what is effect of 5amp fuse on 2mva pry protection of transformer
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
What is thresh hold value of current?
where can the transformer having vector group Yny0 be used??
What is the difference between cylindrical-type and sandwich-type winding?
How can we calculate cable size in Low voltage & high voltage
what is the requirement regarding earthing of Single conductor with AWA
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
send me all basic electrical question and answers
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?