why the CT ratio secondary is always divided by 5 for eg(
75/5,80/5,50/5)
Answer Posted / nagesh
the first part will show the primary current eg 75/5 75 amp
will be your primary current and 5amp represents the
secondary current, but its not always 5, even in market
30/1 and 50/1 etc is also avaiable, but true there is an
standard. Rest all what Iamdon said perfectly ok.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
What is the normal phase difference between the voltage and the no-load current in a transformer?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
What are the types of the glands and difference between single and double compression type of cable Glands.
what is the electrical?
what is the circutor?why we use it ?
What about electrical Units. discrive in detail
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
What is the effect of pd controller on system performance?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
what is the mechanical safety of DG ?
what is the main difference between power devices and signal devices
what is the saturation point of crgo lamination.
Why we find the sensitivity for the CT's to check?