CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE
IT AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND
TAKING OUTPUT FROM PRIMARY?
- 22 Answers
- 23870 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / m.vishwanath
this method can be followed only for testing of transformer
without any doubt but practically cannot be as explained in
ans 2
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
what is d check in dg 1500kva
sir i want previous entrance exam papers for written test
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
what are inherent currents?
What is star-delta transformer?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
What about electrical Units. discrive in detail
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
how desiel generate sart fail of eb?
why ht cable end termination don't have a gland?
