Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the minimum and maximum ohmic value for
earthing?
- 2 Answers
- 6139 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.r.gowri sankar
Earthing Resistance between the phase to earth is must be
below the value is 0.5ohms.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Is the theorem applicable to ac sources?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . y d.c series motor in train.train wheels r driven by D.C shunt motor ,at what voltage,and at what speed. please reply..............
How to checked frequency drive output voltages?
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Why should we hire you over the others waiting to be interview?
what is negative and zero impedance in 3 phase induction motor ??
what is control supply rating of a machine
Define the overload capacity of the motor?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
