Answer Posted / sunil guru
exciter controls the flux thus the emf so that the generator can produce the rated output(by exciting the field poles)
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
if we have 320KVA Genset kindly advice how much load we can put it.
state the disadvantages of carbon filament???
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is the principle of operation of CFL ??
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
How many kw will suply from one db
What are the various types of BUSBAR Schemes? explain each
66kv under ground cable how to layaing in ground any special case two ckt r runing
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is called grain-oriented laminations?
how we provide neutral earth on synchronising panel as per electrical standards?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
how is find out kwh step by step
How many capacitors using in LT panel as per Govt rules?