Is 456 revised lastly in which year? & What are the revisions?
Answer Posted / sathyajeth
it has been revised in 2000 and it has changed m15 grade to
m20
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
What is the difference between EPC,DBOOT and BOOT.
Dear Sir What is the Contraction joint for base Slab
Will water damage concrete?
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
How to determine thee cut length for steel reinforcement bars in R.C.C design
What is min thickness,min grade of conc & age of PQC ?
What glue is least sticky?
how do we calculate quantity of cement sand and aggregates in 1m3 of m20 m25 grade concrete?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
How to calculate the area in squarefeets ?How much area of sqft for this measurements?East 53.3ft West 54ft North 47.7ft South 51.1ft ?
HDPE pipe standard bends using for TSE irrigation? is it possible to use 30 degree?
Calculation of curtain wall of box culvert
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
what"s the sort of beams?
manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.